Smartgen HGM400 Series

HGM400 Series Genset Controller User Manual
HGM400 Series Genset Controller ISSUE 2015-05-27 Version 1.6 Page 9 of 44
4 OPERATION
4.1 PUSHBUTTONS
Stop/ Reset
Stop running generator in Auto/Manual mode;
In case of alarm condition, pressing the button will reset
alarm;
In stop mode, pressing and holding the button for 3
seconds will test indicator lights (lamp test);
During stopping process, press this button again to stop
generator immediately.
Start
Start genset in Manual/Test mode.
Manual
Pressing this key will set the module into manual mode.
Pressing and (or ) simultaneously can
adjust LCD contrast.
Auto
Pressing this key will set the module into auto mode.
Set/Confirm
Pressing this key will enter into Main Menu;
In setting parameter status, press this key will shift cursor
or confirm setting value.
Up/Increase
Scrolls the screen up;
Shift the cursor up or increase the set value in
parameter setting menu.
Down/Decrease
Scrolls the screen down;
Shift the cursor down or decrease the set value in
parameter setting menu.