Smartgen HGM400 Series

HGM400 Series Genset Controller User Manual
HGM400 Series Genset Controller ISSUE 2015-05-27 Version 1.6 Page 22 of 44
Pin
Function
Cable
Size
Description
is recommended) (HGM410 without)
29
Mains AC Voltage N1
1.0mm
2
Connected to N-wire of mains (HGM410
without)
NOTE: LINK interface is parameters programmable interface that can be
programmed by PC using an SG72 adapter. If there is need to remote control the
genset, please use the SG485 module produced by our company.
7 DEFINITION AND RANGE OF PARAMETERS