default setting) to 30 minutes; adjustable in 10 minute incre-
ments in settings from 30 minutes to 3 hours.
6.7 MV:ZN DLY
(Master Valve Advance Open and Delayed Close): This func-
tion allows the user to set a delay time between the opening of
the master valve and the opening of the first zone valve as well
as a delay between the closing of the last zone valve and the
closing of the master valve.
Use the NEXT button to enter menu. Select setting for the ON
Delay or OFF Delay by pressing NEXT. Use ▲ and ▼ arrow
buttons to select delay time. Use arrow buttons to set ON Delay
time from 0 seconds to 1 minute in 1 second increments. OFF
Delay can be set from 0 seconds to 3 minutes in 1 second
increments.
6.8 MV/ZONE
This feature is used to indicate which zones will use the master
valve/pump start relay. Use NEXT button to set each zone ON
or SYSTEM OFF (SmartLine
®
controller default is master valve
ON for all zones). Use ▲ and ▼ arrow buttons to select ON or
OFF. Use NEXT button to select zone.
Caution: If an unused zone is turned on and activates a pump
start relay, the pump may overheat or cause a pipe to burst. To
prevent operating a pump with no flow (dead heading), make
sure all unused zones are set to OFF.
6.9 CLR PGM
This feature allows the user to clear all programmed values spe-
cific to a selected program. All zone run times and daily start
times will be set to OFF; watering days will default to Days of
the Week (all on); Season % will equal 100% for all months
and Run/Soak will be OFF. Omit times/days and Auto Adjust
settings are not reset when clearing a program.
From the CLR PGM menu, press NEXT and the display will
show KEEP. Use PGM button to select program to be cleared.
Then, press either the ▲ or ▼ arrow button to display CLEAR.
With CLEAR showing in the display, either press NEXT or BACK
or turn the dial to complete the clearing of the selected pro-
gram. Likewise, with KEEP showing in the display, either press
NEXT or BACK or turn the dial to keep the selected program.
6.10 WIRELESS
Reserved for future use with wireless remote options.
6.11 ABOUT
Provides information on software version in the SmartLine
®
controller.
To Next Page
Loading...
