SMC Networks 7004ABR - Dialup on Demand Setup

32
Conguring Your Barricade
for Dialup on Demand
1. Select “Dialup on Demand,”
and click “More Conguration.”
2. If the serial port is used for primary
Internet access, then mark the item
“Check if you only use a dial-up modem
to connect to the Internet.” If not marked,
then this connection will only be used
for backup access if the primary WAN
link fails.
3. Enter your ISP account user
name and password in the “Dial-Up
Account Information.”
4. Enter the “ Modem Initialization
String” provided by your modem
manufacturer. The following is a sample
initialization string:
“ATQ1SO=1&D0&K0&W” as dened below:
Q1 : Inhibit result codes to DTE
S0=1 : Auto answer on rst ring
D0 : Don’t care DTR
K0 : Disables DTE/DCE ow control
W : Write command to modem memory
5. In the “Maximum Idle time” eld, enter the maximum idle time for the
Barricade (in second).
6. If you are assigned a dynamic IP address every time you dial up, mark
“No” for “Has your Internet Service Provider given you an IP address?”
However, if your ISP has assigned a xed IP address for you to use, mark
“Yes” for this item and enter the IP address and subnet mask.
7. If your ISP has given you a secondary phone number, or if you have
a secondary Internet service account, then ll in the relevant elds under