SMC Networks 7004ABR - Print Server Configuration; Installing Print Server Monitor

33
Conguring Your Computer
for the Barricade Print Server
If you are not connecting your printer to your Barricade, skip this
section.
With the Barricade’s built-in print server, you can connect your printer
to the Barricade and print from any computer on your network. Each
computer needs to have a “client” installed that will communicate
with the Barricade’s print server. Windows 2000 and UNIX and Linux
operating systems have a print client already installed. If you are
running Windows 95, 98, ME, 2000 or NT, you must use the SMC
Barricade Print Server Monitor as your print client.
Conguring Your Computer for the Barricade Print Server for
Windows 95/98/NT/ME/2000
Step 1: Installing SMC Barricade Print Server Monitor
You must rst install the software that will allow your programs to
print to the printer attached to the Barricade.
1. Insert the Installation CD into your
CD-ROM drive.
2. Click “Start” and “Run…”
3. Type “D:\PrintSvr\Setup” and click
“OK.”
4. InstallShield will guide you through the
installation process. Click “Next >” for each
window and “Finish” when
complete.
5. Windows must reboot for the changes to take place. When asked if
you want to reboot now, select yes and click “OK.”