SMC Networks PFA Series - Page 10

Flow rate setting mode (manual)
Flow rate setting mode (auto preset)
Flow Rate Setting
The display shows .
Press the SET button.
Display changes to input of OUT1 setting value (1).
The setting value and (or ) are
displayed alternately.
 Button: Increases the setting value
 Button: Decreases the setting value
Press the SET
button.
Display changes to input of OUT2 setting value (1).
The setting value and (or ) are
displayed alternately.
 Button: Increases the setting value
 Button: Decreases the setting value
Display changes to input of OUT2 setting value (2).
The setting value and (or ) are
displayed alternately.
 Button: Increases the setting value
 Button: Decreases the setting value
Display changes to input of OUT1 setting value (2).
The setting value and (or ) are
displayed alternately.
 Button: Increases the setting value
 Button: Decreases the setting value
SET
Press the  button to switch
the display to .
OUT1 OUT2
OUT1 OUT2
OUT1 OUT2
OUT1 OUT2
OUT1 OUT2
OUT1 OUT2
OUT1 OUT2
OUT1 OUT2
OUT1 OUT2
OUT1 OUT2
OUT1 OUT2
OUT1 OUT2
Press the SET
button.
SET
Press the SET
button.
SET
Setting is completed
when the SET button
is pressed.
SET
Press the SET
button.
SET
Setting is completed
when the SET button
is pressed.
SET
Press the SET
button.
SET
OFF point
ON point = C.C1
OFF point = C-3 digits, C1-3 digits,
(1 digit is the minimum setting unit.)
1.
Setting Value Input
Mode (Manual)
2.
Setting in the
Manual Mode
3.
OUT1 Setting
Value (1) Input
Press the SET button.
(Refer to Table 2 for the relationship
of each value to the switch output.)
4.
OUT1 Setting
Value (2) Input
5.
OUT2 Setting
Value (1) Input
6.
OUT2 Setting
Value (2) Input
1.
Setting Value
Input Mode
2.
Setting in the Auto
Preset Mode
3.
Auto Preset
Preparations
In this condition, preparations are performed on
equipment for the OUT1 setting, and flow is
started.
In case the OUT1 setting is not
required, press the  button and the
 button simultaneously while in this
condition.
Press the SET button, and then
release it when is displayed.
6. OUT2 Auto Preset
5.
Auto Preset
Preparations
4. OUT1 Auto Preset
When the SET button is pressed at this point,
the flow rate values are read automatically,
and the optimum setting value is input.
and the input value are displayed
alternately.
Hysteresis
(3 digits)
ON point
(C.C1)
Preparations are performed on
equipment for the OUT2 setting, and
flow is started.
In case the OUT2 setting is not
required, press the  button and the
 button simultaneously while in this
condition.
When the SET button is pressed at
this point, the flow rate values are
read automatically, and the optimum
setting value is input.
and the input value are
displayed alternately.
Series PFA
6