Operation
Performs the display setting.
Changes with the UP button.
: Real-time flow rate
: Accumulated flow
Press the SET button.
Performs setting of display units.
Changes with the UP button.
Performs setting of the OUT1 output specification.
Changes with the UP button.
: Real-time switch output
: Accumulated switch output
: Accumulated pulse output
∗ Refer to "OUT1 Output Specification" for details.
Performs setting of the OUT1 output type.
Changes with the UP button.
: Non-inverted output
: Inverted output
Performs setting of the key lock.
Changes with the UP button.
: Key operation permitted
: Key operation prohibited
1. Initial Setting Mode
Press the SET
button.
SET
Press the SET button.
SET
Press the SET
button.
SET
Press the SET
button.
SET
Press the SET
button.
SET
Setting is completed
when the SET button
is pressed.
SET
2. Display Selection Mode
Setting is completed
when the SET button
is pressed.
SET
Performs setting of the display mode.
Changes with the UP button.
: Real-time flow rate
: Accumulated flow
Press the SET button.
3. Display Unit Selection Mode
Setting is completed
when the SET button
is pressed.
SET
Press the SET button.
Display
Real-time
flow rate
l/min
CFM
Accumulated flow
l, m³, m³ x 10³
ft³, ft³ x 10³, ft³ x 10⁶
Table 1
Flow rate
setting
For -M (fixed SI unit)
Performs setting of display units.
Changes with the UP button.
(Refer to Table 1 .)
Changes to when the MODE button is pressed.
Note 1)
Note 1)
Unit number
∗ Refer to "Display Unit Selection
Mode" for details. For -M
specification (fixed SI unit), the
display unit setting is not available.
Performs the setting value input.
∗ Refer to "Flow Rate Setting
Mode" for details. When
is selected, the flow
rate setting is not available.
For
For
Unit number
Changes to when the MODE button
is pressed. [ for -M specification (fixed
SI unit)]
Note 1) For the type with unit switching function
[The type without the unit switching function will have a fixed SI unit (
l/min, or l, m³ or m³ x 10³)].
To Next Page
Loading...
