Do not cut the inlet hose (see Fig. 14)
If the hose is cut, the dihwasher will not work, water will leak and you may
be injured. If the hose is too long, wind it up tidily and place it behind the
appliance. The cable harness and electrical components must not come
into contact with the hydraulic system and the water inlet and drain hoses.
When connecting the dishwasher drain hose to the sink make sure that the
hose is not bent (ref. A fig. 15) in order to prevent cracks or breakages
that could damage it.
INSTALLATION INSTRUCTION
Fig. 14
Fig. 15
EN
17
To Next Page
Loading...
Need help?
General
