Smeg STU8642 User Manual

2.2.3 End of program
The end of the program is signaled by a short beep. Additionally the indi-
cator light of the normal and strong programs (marked “end”) flash.
PROGRAM IN PROGRESS INDICATOR LIGHT
(on some models only)
When a program is running, a flashing light is projected onto the floor un-
der the right-hand corner of the door. At the end of the program, the light
goes out to reduce sleep mode electricity consumption.
2.2.4 Interrupting a program
To interrupt the current program simply open the door of the dishwasher;
to restart the program, simply close the door again. The program restarts
from where it was interrupted.
2.2.5 Changing the current program
To change the current program, simply open the door of the dishwasher
and select the new program. Close the door to run the new program au-
tomatically.
2.2.6 Canceling the current program
• To cancel the current program, open the door and press and hold down the
program selection button (ref. 3 fig. 2-02) for a few seconds until the indica-
tor lights of the fourth and fifth programs turn on (ref. pr. 4, pr. 5 fig. 2-03).
• Close the door again.
• After about 1 minute, the dishwasher terminates the cycle and the in-
dicator lights of the fourth and fifth programs (ref. pr. 4, pr. 5 fig. 2-03)
start flashing.
QuickTime
end
QuickTime
Sanitized
1131410 6789432 5
½
1112
Auto
end
Auto
end
Auto
end
Auto
end
Auto
end
Auto
end
Auto
end
Auto
end
Auto
end
Auto
end
Auto
end
Auto
end
Auto
E1
E2
E3
E4
E5
E6
E7
E8
E9
E11
symbols programs according to the models FIG. 2-03
USER INSTRUCTIONS
11
EN

Smeg STU8642 Specifications

General

Brand	Smeg
Model	STU8642
Category	Dishwasher
Language	English