To Next Page

To Previous Page

4 TROUBLESHOOTING

The dishwasher can to signal a number of malfunctions by turning on vari-

ous indicator lights, as described below (see following table):

FAULT

DESCRIPTION

Acquastop failure

The anti-flooding system has tripped (only

for models fitted with this feature). Acti-

vates in case of water leaks. Contact the

technical assistance service.

Safety level

The system limiting the water level in the

dishwasher has tripped. Interrupt the cur-

rent program. Switch off the dishwasher,

switch it back on again, program a new cy-

cle and press start. If the problem persists,

contact the technical assistance service.

Water heating malfunction

The water is not heated or is incorrectly

heated. Repeat the washing program; if

the problem persists, contact the technical

assistance service.

Water temperature monitoring malfunction

Interrupt the current program. Switch off

the dishwasher, switch it back on again,

program a new cycle and press start. If the

problem persists, contact the technical as-

sistance service.

Water intake malfunction

The appliance does not take in water or

does so incorrectly. Make sure the water

connections are correct, that the water

supply tap is open and that the filter is not

clogged. If the problem persists, contact

the technical assistance service.

Tab. 4-01a

USER INSTRUCTIONS

Smeg STU8642 User Manual

Other manuals for Smeg STU8642