5.2.1 Adding the rinse-aid
The rinse aid helps the dishes dry faster and prevents the formation of
scale deposits and staining; it is automatically added to the water during
the final rinse cycle, from the container situated on the inner side of the
door.
A
C
B
Fig. 5-04
To add rinse aid:
• Open the door.
• Rotate the container cover (ref. A fig. 5-04) anticlockwise by ¼ of a turn
and remove it.
• Add the rinse aid until the container is full (approximately 140 ml). The
optical level indicator (ref. B fig. 5-04), on the side of the cap should be
completely obscured. Refill the rinse aid when the optical level indica-
tor becomes clear again, or when the rinse aid warning light illuminates
(see “Description of controls” manual).
• Replace the cover (ref. A fig. 5-04) by turning it in a clockwise direction
until it is fully closed.
• Use a cloth to remove any spillage of rinse aid which might lead to the
formation of excess foam.
5.2.2 Adjusting the rinse-aid dispenser setting
The rinse-aid dispenser can be set to one of 6 different levels. The dish-
washer is factory set for medium water hardness (selector set to “3”). To
change the setting, turn the dispenser selector (ref. c fig. 5-04) to the
desired position: the amount of rinse-aid dispensed is proportional to the
position of this selector. Make sure that the minimum amount of rinse-aid
(selector turned to “1”) is approximately 1 ml and the maximum amount
(selector turned to “6”) is approximately 6 ml.
USER INSTRUCTIONS
21
EN
To Next Page
Loading...
Need help?
General
