Why did the color of the clothes fade after washing in my Smeg WHT812LIT Washer?
If the color of your clothes faded after washing in your Smeg Washer, you might have loaded too much laundry. The detergent in use could be damp, or a higher temperature might have been selected. Select the proper program and temperature according to the type and soiling degree of the laundry.
How to open the loading door of my Smeg Washer?
If you cannot open the loading door of your Smeg Washer, it may be due to a few reasons. The door lock might be activated because of the water level in the machine; drain the water by running the Pump or Spin program. If the machine is heating up the water or is in the spinning cycle, wait until the program completes. Lastly, the child lock may be engaged; wait a couple of minutes after the program ends for the door lock to deactivate.
Why won't my Smeg WHT812LIT switch to the spinning step?
Your Smeg Washer might not switch to the spinning step due to several reasons. There could be an unbalanced load in the machine. Also, the machine will not spin if the water is not drained completely, so check the filter and the draining hose. Excessive foam from too much detergent can also prevent spinning; use the recommended amount of detergent.
How to start the Smeg WHT812LIT Washer program after closing the door?
If the program on your Smeg Washer doesn't start after closing the door, it might be because the Start / Pause / Cancel button was not pressed. Press the Start / Pause / Cancel button.
Why is my Smeg WHT812LIT Washer vibrating or making noise?
If your Smeg Washer is vibrating or making noise, several factors could be the cause. First, ensure the machine is standing balanced by adjusting the feet. A hard substance in the pump filter can also cause this issue, so clean the pump filter. Check that the transportation safety bolts have been removed. The laundry quantity might be too little or too much; adjust the load accordingly. Finally, make sure the machine isn't leaning on anything.
Why does washing take longer than specified in the Smeg WHT812LIT manual?
Several factors can cause your Smeg Washer to take longer than the time specified in the manual. Low water pressure can cause the machine to wait until it takes in enough water, extending the wash time. Low voltage or a low input water temperature can also prolong the washing time. The number of rinses or the amount of rinse water might have increased. Finally, excessive foam due to too much detergent can activate the automatic foam absorption system, lengthening the cycle.
What to do if the programme cannot be started or selected on my Smeg WHT812LIT?
If a program cannot be started or selected on your Smeg Washer, the machine may have switched to self-protection mode due to a supply problem (line voltage, water pressure, etc.). Press and hold the On/Off button for 3 seconds.
Why did my Smeg WHT812LIT stop shortly after the programme started?
Your Smeg Washer might have stopped temporarily due to low voltage. It will resume running when the voltage restores to the normal level.
Why does laundry become stiff after washing in my Smeg WHT812LIT Washer?
If laundry becomes stiff after washing in your Smeg Washer, it could be due to using an insufficient amount of detergent for the water hardness. Ensure you use an appropriate amount of detergent. Check that the detergent is put in the correct compartment and not mixed with the softener. If detergent is put in the prewash compartment although prewash cycle is not selected, machine can take this detergent during rinsing or softener step. Put the detergent in the correct compartment.
Why does laundry turn gray after washing in my Smeg WHT812LIT?
If your laundry turns gray after washing in your Smeg Washer, it could be due to using an insufficient amount of detergent over a long period, or washing at low temperatures for a long time. Insufficient detergent with hard water can also cause graying. Avoid using too much detergent.
General| Appliance placement | Freestanding |
|---|---|
| Product colour | White |
| Built-in display | Yes |
| Door hinge | Left |
| Drum material | Stainless steel |
| Rated capacity | 8 kg |
| Maximum spin speed | 1200 RPM |
| Spin-drying class | B |
| Washing class | A |
| Number of washing programs | 16 |
| Quick washing program | Yes |
| Pre-wash program | Yes |
| Rinse Plus function | Yes |
| Delayed start timer | Yes |
| Delay start | 24 h |
| Remaining time indication | Yes |
| Energy consumption per 100 cycles | 63 kWh |
| Energy consumption washing per cycle | 0.63 kWh |
| Power consumption (standby) | 0.5 W |
| Power consumption (off) | 0.5 W |
| Connected load | 2200 W |
| Current | 10 A |
| Weight | 68 kg |
| Loading type | Front load |
| Control type | Rotary |
| Width | 60 cm |
| Height | 850 mm |
To Next Page
