Smith-Root eDNA Sampler - System Components and Safety; Stand-alone and Backpack Sampler Views; Critical Operation Warnings

3
INSTRUCTION MANUAL
2019
WARNINGS
Product may contain a Lithium Iron Phosphate battery. Failure to follow instruc-
tions may void warranty.
• Do not short circuit battery leads
• Do not drop battery
• Do not heat above 60°C
• Only use approved charger
• Ensure correct polarity when charging and when connecting to the system
• Do not reuse battery if you suspect it has been damaged in any way
A. Control/display panel
B. USB connector
C. Speaker/Volume
D. Power Switch
E. Water inlet
F. Water outlet
G. GPS antenna
H. Remote Control Unit
I. Input power cable
J. Battery (standalone sampler)
K. Harness*
L. Upper dry bag*
M. Lower dry bag*
N. Waterproof door*
*Backpack unit only
A
B
C
D
E F
G
H
I
J
K
M
N
L
Backpack sampler
Stand-alone sampler
• Do not crimp or clamp tubing to the OUT port on the unit. This serves as a pres-
sure blow-off if the tubing is accidentally blocked.
• Prolonged direct sunlight on display electronics may compromise product per-
formance
• Do not Freeze. Storage or operation in freezing conditions can damage internal
components.
• Always operate unit with a filter housing installed. Do not allow sand or large
particles to be sucked inside the unit. This will damage the pump.