7
WELDING
Make sure that the welding machine is set for the wire
diameter and type of aluminium to be welded.
Make sure that the PUSH-PULL welding torch. Has the
correct
R
roller with ne diameter corresponding to the
wire being used and installed the right
T
contact tip.
Set the power source current, according to the job to be
carried out.
Get close to the welding point and press the welding
torch button
V
.
Using the “UP-DOWN” button
W
, you can adjust the
welding current.
NO
TS
Z
P
R1
R
V
Q
U
J
X
U
Y
To Next Page
Loading...
