10
Note: To select a stored PSET or manual target torque or angle mode, repeatedly press ENTER
buttonuntil desired PSET or manual mode is displayed.
Editing a Preset
Edit PSET function gives user ability to edit stored PSETS on wrench.
1. From Preset screen to be edited, press and hold UNITS U button for 3 seconds.
2. CHANGE PRESET screen is displayed.
3. Highlight EDIT selection using UP S /DOWN T buttons then press ENTER button.
4. MINIMUM TORQUE or ANGLE screen is displayed. Value can be changed by pressing
UP S /DOWN T buttons. Once desired target torque or angle value has been set, press
ENTER button.
5. MAXIMUM TORQUE or ANGLE screen is displayed next. Value can be changed by pressing
UP S /DOWN T buttons. Once desired target torque or angle value has been set, press
ENTER button.
6. BATCH COUNT screen is displayed next. Value can be changed by pressing UP S /DOWN T
buttons. Once desired batch count value has been set, press ENTER button.
7. PSET target screen is displayed labeled with same PSET number.
Note: Pressing ENTER button while EXIT menu selection is highlighted will exit without editing
PSET.
BATCH COUNT
CHANGE PRESET
DELETE
EDIT
CHANGE PRESET
DELETE
EDIT
MINIMUM ANGLE
MAXIMUM ANGLE
To Next Page
Loading...
Need help?
General
