15
Turn the AA -Knob watching the Z - Display.
Set the slope up to “0” seconds.
Push the P – Selector (Right Arrow) until the T –
LED main welding current display lights.
(10-130A in MMA and 5-150A in TIG)
Turn the AA knob while watching the Z display.
Z DISPLAY
Adjust the display to the required main welding amperage.
Rule of Thumb: “1 amp per .001 of plate thickness.
(.125 = ~125 amps)
Use the following as a guide for
setting up the amperage:
** May require multiple passes.
Push the P – Selector (Right Arrow) until the W –
LED slope down display lights.
W - LED
Slope down. This is the time in which the current reaches
the minimum and the arc shuts off. (0-10 seconds).
Turn the AA - Knob watching the Z - Display.
Set the slope down to “0” seconds.
Push the P – Selector (Right Arrow) until the X –
LED post gas display lights.
Post Gas Adjusts the time gas flows after the welding
ends. ( 0-30 seconds)
Turn the AA - Knob watching the Z - Display.
Set the post gas to “10” seconds.
Basic TIG AC Setup is Complete
To Next Page
Loading...
