54
|
Laser Engraving and Cutting
1. Download our software the Snapmaker Luban at https://www.snapmaker.com/download and install. Then
connect to a Wi-Fi network: Enter the Workspace -> Connection -> Select Wi-Fi -> Click -> Select your
machine -> Click Open -> Tap Yes on the Touchscreen
.
2. Click Camera Capture in the Laser G-code Generator and then click Start. Wait for the machine to take
photos and stitch them into a panorama of the platform, and click Confirm.
4.3 Prepare the G-code File and Start Cutting
Guides & Pictures / Snapmaker
To Next Page
Loading...
