Snapmaker Enclosure A150 - Page 15

22
|
Snapmaker Enclosure
|
23
Enclosure Assembly
15
/28
Connect the 80 × 20 Exhaust Fan to the Enclosure Converter.
16
/28
Bury the Door Switch Cable and the left LED Strip Cable into the grooves
of the beams. Fix the cables with Cable Clips.
Tilt the snap joint of the Cable
Clip and press it against the
groove of the beam to clip it
in. The sheet of the Cable Clip
should hold the cable inside the
adjacent groove.
Cable Clip × 8