24
|
Snapmaker Enclosure
|
25
Enclosure Assembly
17
/28
Bury the Exhaust Fan Cable and the right LED Strip Cable into the grooves
of the beams. Fix the cables with Cable Clips.
Cable Clip × 5
18
/28
Transfer the machine to a proper place and enclose the machine with the
frame from above.
The provided vent
duct measures
75mm in diameter
and 2m in length. For
the convenience of
venting, please choose
the position properly.
Tilt the snap joint of the Cable
Clip and press it against the
groove of the beam to clip it
in. The sheet of the Cable Clip
should hold the cable inside the
adjacent groove.
To Next Page
Loading...
