28 snapperpro.com
27
Changing the Engine Oil and Filter
(Engines with Remote Oil Tank)
Engine Oil Type: 15W-50 synthetic oil. (See the engine
operator's manual for other oil recommendations.)
Engine Oil Change Amount: 5 qt (4,73 L).
Oil Change Interval: Every 500 hours.
Important:Always make sure that the mower is parked on a
flat, level surface when checking the engine oil level.
1. Park the machine on a flat, level surface. Engage the
parking brake and disengage the PTO. Allow the engine
to run until it is warm. This will warm the oil so it will
drain better. Turn the ignition switch to OFF, remove the
ignition key, and wait for all moving parts to stop before
leaving the operator's position.
2. Clean the area around the engine oil dipstick (A, Figure
28) and oil fill cover (B) to remove any debris.
28
3. Remove the engine oil dipstick and wipe with a clean
cloth.
4. Cut the self-locking tie (C) that keeps the oil fill cover
securely closed. Open the oil fill cover.
5. Have a suitable container ready to capture dripping oil
from the engine oil filter (D) after it is removed. Remove
the oil filter by turning it counter-clockwise a 1/4 turn (E)
and then pulling up. Dispose of the used oil filter properly.
6. This mower is equipped with an oil drain valve (A, Figure
29) that is used to drain the oil from the remote oil tank.
The drain is located on the right side of the engine at the
rear of the machine and is routed through the mower's
engine deck. To catch the drained oil, place a suitable
container underneath the mower's engine deck.
To Next Page
Loading...
