What to do if my SNBC KIOSK buzzer alarms?
If the buzzer alarms, it could be due to a paper end. Replace the paper roll to solve this. Another possible cause is that the printer cover is not fully closed. Ensure that you close the printer upper cover completely.
Why is my SNBC KIOSK not feeding paper automatically?
If your printer isn’t feeding paper automatically, it could be due to several reasons. The paper head might be irregular, in which case you should clear any wastepaper. Another cause may be paper jams, so remove any jammed paper. Also, the paper load sensor might not be fully covered by the paper head. Check the front end of the paper to ensure the paper-load sensor is completely covered. Finally, dust or wastepaper may be covering the paper loading sensor; clean the sensor in this case.
What to do if after auto paper feeding, the paper can’t stop in the normal print position in SNBC KIOSK Printer?
If, after auto paper feeding, the paper doesn’t stop in the normal print position, it's possible that dust or wastepaper is covering the paper loading sensor. Clean the paper loading sensor to resolve this issue.
General| Print Width | 72mm |
|---|---|
| Resolution | 203DPI |
| Paper Width | 80mm |
| Paper Type | Thermal Paper |
| Paper Thickness | 0.06-0.08mm |
| Interface | USB |
| Power Supply | 24V DC |
To Next Page
