Snom D7C - Update via Provisioning

24
Snom D7C User Manual Firmware update
◦ Before the update, disconnect other modules from the phone.
Note: After an update via provisioning, the firmware_uxm parameter is set to the
phone's URL to keep the phone from repeatedly downloading the update le and
updating the expansion module. If you are provisioning updates for more than one
D7C from the same phone, you must replace the phone's URL in the firmware_uxm
parameter with the update le's URL before updating the next module.
1. Connect the expansion module you want to update to your phone. Wait until its LEDs have lit up
and gone out and the labels are shown on the display.
2. Set the firmware_status setting to the update le's HTTP URL. The progress of the update
is shown on the phone's display. When the update has been completed, phone and expansion
module will reboot.
3. Repeat for each module to be updated.