Chapter 1 – Introduction
2 S2255RT S2755RT - 15286-1
Maintenance
Complete machine inspection consists of periodic vi-
sual and operational checks, along with periodic minor
adjustments that assure proper performance. Daily
inspection will prevent abnormal wear and prolong the
life of all systems. The inspection and maintenance
schedule should be performed at the specifi ed intervals
and after prolonged periods of storage before returning
the machine to service. Inspection and maintenance
shall be performed by personnel who are trained and
familiar with mechanical and electrical procedures.
Every person who maintains, inspects, tests, or repairs
the aerial platform must be qualifi ed to do so. Following
the daily prestart inspection in this Operator’s Manual
will help keep the aerial platform in optimum working
condition. Other maintenance functions must be per-
formed by maintenance personnel who are qualifi ed
to work on the aerial platform.
Caution
Welding current can be very intense. Damage to
electronic components may result. Connect the
ground clamp as close as possible to the area
being welded. Disconnect battery cables and any
microprocessors and engine control modules
before welding on the machine.
If it becomes necessary to weld aerial platform com-
ponents as a method of repair, take all precautions to
prevent damage to electronic circuitry and devices on
the machine. This includes, but may not be limited to,
disconnecting battery cables and electronic devices.
Do not modify this aerial platform without prior writ-
ten consent of the Snorkel Engineering Department.
Modifi cation may void the warranty, adversely aff ect
stability, or aff ect the operational characteristics of the
aerial platform.
Manual of Responsibilities – ANSI
All owners and users of the aerial platform must read,
understand, and comply with all applicable regulations
as stated in ANSI A92.20. Ultimate compliance to ANSI
and OSHA regulations is the responsibility of the user
and their employer.
ANSI publications clearly identify the responsibilities
of all personnel who may be involved with the aerial
platform. A reprint of the “Manual of Responsibilities
for Manufacturers, Dealers, Owners, Users, Supervi-
sors, Operators, Occupants, Lessors, Lessees and
Brokers of ANSI/SIA A92.22-2020 Safe Use & ANSI/
SIA A92.24-2018 Training Requirements for the Use,
Operation, Inspection, Testing and Maintenance of
Mobile Elevating Work Platforms (MEWP)” is available
from Snorkel dealers or from the factory upon request.
Copies are also available from:
Scaff old & Access Industry Association
400 Admiral Boulevard
Kansas City, MO 64106 USA
MEWP Safe Use – AS/NZS
All owners and users of the aerial platform must read,
understand, and comply with all applicable regulations
as stated in AS/NZS 2550.10:2006. Ultimate compliance
is the responsibility of the user and their employer.
AS/NZS 1418.10 Commissioning
Per AS/NZS 1418.10, a machine has been commis-
sioned upon return to Snorkel of a satisfactory completed
Pre-Delivery and Inspection Record (PDIR). The PDIR
inspection is performed by Snorkel, or it’s agent, before
the machine is delivered to the customer. A completed
PDIR form can be obtained, by request, from the sales
agent.
Additional Information
For additional information contact your local dealer or
Snorkel at:
Snorkel International
P.O. Box 1160
St. Joseph, MO 64502-1160 USA
1-800-255-0317
http://www.snorkellifts.com
Regional contact information is located on the back
cover of this manual.
To Next Page
Loading...
