n
Engine Coolant
Figure 7.7 - Engine Coolant Level
The Kubota en gine is liq uid cooled. The cool ant
should be be tween the FULL level and the LOW
level (see Fig ure 7.7).
The cool ant is half wa ter and half eth yl ene gly col.
To add cool ant:
Turn the engine OFF at the ground control box box
KEY SWITCH. Remove the cap (see Figure 7.7)
from the coolant reservoir. Add coolant and replace
cap.
n
Radiator Cap
Figure 7.8 - Radiator Cap
Vi su ally check to see that the cap is in place and
tight.
n
Swinging Gate
Figure 7.9 - Swinging Gate
In spect the gate to see that it swings freely, latches
se curely, and is not de formed in any way.
n
Wiring Harnesses and Connectors
In spect all the wir ing har nesses, on the ma chine,
for loose con nec tions, bro ken wires, and frayed in -
su la tion.
Figure 7.10 - Wiring Harnesses and
Connectors
Figure 7.11 - Wiring Harness in the Scissor
Stack
Pay par tic u lar at ten tion to the wir ing har nesses
that are at tached to the scis sor stack. Note that the
wire har ness runs beside the main hose bundle.
page 7 - 4 Rev A S3970RT, S3370RT & S2770RT – 13865-1
7. Daily Inspection and Maintenance
To Next Page
Loading...
