Figure 7.20 - Structural Damage and Welds
Vi su ally in spect all welds for cracks, all struc tural
mem bers for de for mity, and all sheet metal for
dents that could in ter fere with ma chine op er a tion.
n
Primary Fall Restraint System
Figure 7.21 - Primary Fall Restraint System
En sure that all hand rails are lo cated cor rectly with
each other and that all pins and bolts are in place.
If any part of the Fall Re straint Sys tem is not in
place the Sys tem is com pro mised and the op er a tor
must re view the Risk and Haz ard Anal y sis and
de ter mine ways to pro vide ad e quate fall pro tec tion
e.g. the use of Fall Re straint Har nesses, Lan yards,
and An chors.
n
Bubble Level
Figure 7.22 - Bubble Level
Vi su ally check to see that the bub ble level is not
dam aged, that it is full of fluid, and the sur face on
which the bub ble level is mounted is not de formed
or bent out of level.
n
Guides, rollers, and slides
Figure 7.23 - Guides Rollers and Slides
Vi su ally check slides and roll ers for wear or
dam age. Be sure that the guides are free of de -
bris and al low the slides and roll ers to move
smoothly.
NOTE
Start the engine and leave it running for the next
step
n
Ground Controls
Figure 7.26 - Ground Controls
S3970RT, S3370RT & S2770RT – 13865-1 Rev A page 7 - 7
7. Daily Inspection and Maintenance
To Next Page
Loading...
