Snorkel S3970RT - Operating the Stabilisers Manually; To Set the Stabilisers; To Raise the Stabilisers

n
Operating The Stabilisers Manually
q To set the stabilisers
1. The engine must be running and the
S3970RT / S3370RT / S2770RT set for
platform control box operation.
Note:
In order to operate any of the stabilisers you
must squeeze the joystick trigger w at the same
time as you operate the individual stabiliser
switches .
You must do this when raising or lowering the
stabilisers.
Figure 8.11
2.
Pull and hold the Stabiliser switches  (see
Figure 8.11)backward, one (1) at a time, until
all four (4) stabiliser pads  (see Figure
8.12) contact the ground.
Figure 8.12
Figure 8.13
3.
Visually check the bubble level  to
determine which stabilisers must be further
extended to level the platform (see Figure
8.13).
NOTE
When the bubbles  and  are in the center of
the marks the platform is level.
4. Lower the ap pro pri ate sta bi lis ers just enough
to cen ter the bub bles  and  (see Fig ure
8.13). When the Lift In di ca tor Light  (see
Fig ure 8.14) co mes on, the plat form can be
safely raised.
Figure 8.14
q To raise the stabilisers:
1. Completely lower the platform.
Figure 8.15
page 8 - 6 Rev A S3970RT, S3370RT & S2770RT – 13865-1
8. Operation
T