Android: Connect Android Device in Basic Mode (HID)
In this mode the scanner functions and communicates similar to a key-
board. Therefore, scanner will work with Notes, and any other
application that supports an active cursor.
1. Power on the scanner. Make sure the scanner is
discoverable (unpaired) and the blue light blinks fast.
2. Go to Settings | Bluetooth.
3. Make sure the device’s Bluetooth is turned “On” to scan for devices.
4. In the list of found devices, select Socket CHS [xxxxxx]. Tap Pair.
5. The scanner will connect to the Android device.
6. The scanner will beep once after it has connected.
Note: If you have trouble connecting or pairing with host device, turn
host device’s Bluetooth off/on, and/or perform factory reset to the
scanner (see page 44).
Now you are ready to scan barcodes!
To connect to a new device or use a different prole (mode) on
the same device, you must rst unpair the scanner (see page 22).
10
To Next Page
Loading...
