Note: This procedure will put the SocketScan in discoverable mode.
Step 1: Unpairing the scanner: Delete the Bluetooth Pairing
If the scanner is paired with a device, unpair it before trying to
connect to a different device.
a. Power on the scanner.
b. Press the trigger button then power button and hold both until
you hear 3 beeps.
The scanner will unpair and automatically power off. The next time you
power on the scanner, it will be discoverable.
Step 2: Remove or forget the scanner from the Bluetooth list on the
host device.
Important: Both steps above must be done to complete
the unpairing.
21
To Next Page
Loading...
