SoClean 3

FILTER
The Filter converts ozone in your SoClean 3
and sleep equipment mask and hose into fresh
air as it exhausts from the unit. This component
must be replaced at least every 6 months. Your
SoClean 3 reminds you when it needs
replacement.
OZONE TUBE
One end of the Ozone Tube connects to your SoClean
Adapter, and the other end comes already attached to the
back of the SoClean 3. This tube is what circulates ozone or
air through your sleep equipment mask and hose during the
Maintenance Cycle and Fresh Air Cycle.
POWER INPUT
The cable from
the Power Supply
provided with your
SoClean 3 plugs
in here.
PHONE
CHARGING
PORT
A USB port is
provided on the back
of your SoClean 3 to
conveniently charge
your cell phone when
your SoClean 3 is
connected to power.
FILTER DOOR
Your Filter goes in here.
The SoClean 3 unit will
not operate a Maintenance
Cycle or Fresh Air Cycle
if the Filter Door is open.
YO U R S O C L E A N 3 : PA R T S & I C O N S
YO U R S O C L E A N 3 : PA R T S & I C O N S
LID LATCH
Keeps the Lid of the SoClean 3 closed
securely during the Maintenance Cycle
and Fresh Air Cycle.
LID GASKET
Seals the Lid in order
to contain ozone
within the Chamber.
HOSE DETECT
SENSOR
Your SoClean 3 will
only operate when
properly configured.
A Maintenance Cycle
or a Fresh Air Cycle
will not begin unless
a sleep equipment
hose is detected and
the Lid is closed.
MAINTENANCE
CHAMBER
Place your mask,
while still connected
to the hose, inside
the Chamber before
running a Maintenance
Cycle. The inside of the
Chamber is illuminated
for visibility in low-light
settings.
NOTE:
SoClean 3 Lid can only
be opened when the
device is plugged in.
12 13