YO U R S O C L E A N 3 : PA R T S & I C O N S
YO U R S O C L E A N 3 : PA R T S & I C O N S
INDICATOR LIGHTS
There are 7 illuminated indicator lights on the Control Panel that the SoClean
3 uses to communicate with you. The icons are o if the device is idle and
operating normally. See the notes to follow about why these icons may
illuminate and when you can expect to see them.
a
b c d e
f
g
Solid Green
Indicates that either a Maintenance Cycle or Fresh Air Cycle is
complete and that the Lid can be opened.
a
CYCLE COMPLETE
Solid Red/Flashing Red
Indicates when your SoClean 3 has detected an internal issue.
See troubleshooting guide.
b
FAULT/UNABLE TO RUN
Flashing Amber
Indicates that it is time to order a new Filter. From the time it
begins to flash amber, you have 30 days or 30 uses (whichever
comes first) to replace the Filter. You can still use your SoClean 3
to maintain your sleep equipment hose and mask during this time.
Solid Amber
See troubleshooting guide.
c
FILTER ISSUE
FILTER DOOR ISSUE
d
Solid Amber
Indicates that the Filter Door is not completely closed.
Check your Filter Door and open/close it securely.
HOSE NOT DETECTED
e
Solid Amber
Indicates that your sleep equipment hose is not present or
detected when the Lid is closed.
Flashing Amber
Indicates an error detecting the hose or in process of detecting a
hose. This may be the first time the SoClean 3 has been powered
on or there has been loss of power to the device. Open and
close Lid with mask and hose installed to continue.
NOTE: Your SoClean 3 will not operate a Maintenance Cycle
or Fresh Air Cycle if your mask and hose are not installed or
detected in the unit with the Lid closed.
16 17
To Next Page
Loading...