socomec COUNTIS E27 - 9 Configuration; Onscreen Configuration

13EN
COUNTIS E27/E28 - 545881A - SOCOMEC
9. CONFIGURATION
The device can be congured directly from the COUNTIS E27/E28 screen in programming mode or via the
communication link. The paragraphs below describe conguring using the screen.
9.1. Onscreen conguration
From the screen, go to programming mode to change your communication settings. How to browse through the
programming mode is described in the following stages:
Function Where Buttons Press
Switch menus
Every page with the
exception of SETUP 1/2
Realtime
Switch pages within a menu Every page within a menu
Realtime
Go to menu SETUP 2 Menu page SETUP
>3 sec
Go to menu SETUP 1
Every page with the
exception of SETUP 1
SET >3 sec
Change a value/digit Pages SETUP 1/2
Realtime
Confirm a value/digit Pages SETUP 1/2
Realtime
Exit menu SETUP 1/2 Menu SETUP 1/2
>3 sec
Start/stop the displayed partial meter Partial meter menu
+
Realtime
Reset the displayed partial meter to zero Partial meter menu
+
>3 sec
Display test
Every page with the
exception of SETUP 1/2
+
>10 sec