socomec DATALOG H80 - Publish Data Tab; Configure the Activity Report

22
EN
DATALOGGER H80-81 - 546226A - SOCOMEC
) depending on whether it is DATALOG H80/H81 that establishes the TCP connection (passive mode) or
the remote server (active mode).
- Secure communication: Activate a secure session between DATALOG H80/H81 and the remote server
4.5.2. “Publish data” tab
DATALOG H80/H81 publishes data les for each type of selected variable (Load curve, Measurements, Index,
Alarm, Status)
For each type of variable, the user:
• Consolidated data: species whether he wants a single le for all devices or a le for each device
• Send les: denes how often reports should be sent: every X minutes or on a specic day at a specic time of the
week (by default the report frequency is disabled - set to “never”)
4.6. Congure the activity report
To monitor DATALOG H80/H81 operations, the user can congure the sending of a periodic activity report.
This report tracks 3 essential aspects of the daily running of DATALOG H80/H81:
• Communication faults between DATALOG H80/H81 and the device
• Quality faults of the data sent to DATALOG H80/H81
• Communication faults with the remote server (HTTP or FTP)