socomec DIRIS Digiware C Series - TE Solid-Core Current Sensors

17EN
#(1(2#(&(6 1$ŰŰ$2.".,$"
4.2.1. TE solid-core current sensors
The TE solid-core current sensors are used to set up measurement points in a new or existing installation. They are
D@RXSNHMSDFQ@SD@RSGDX@QDBNLO@BS@MCL@SBGSGDOHSBGNESGDBHQBTHSAQD@JDQR VHCDQ@MFDNE@BBDRRNQHDR@QD
@KRN@U@HK@AKDENQCHQDBSjSSHMFNM@KKSXODNEB@AKHMFB@AKDkDWHAKDNQQHFHCATRA@QNQNM@#(-Q@HKRTOONQSNQOK@SD
3G@MJRSNSGDRODBHjBKHMJSGDX@QDQDBNFMHRDCAX#(1(2#HFHV@QD@MC@GHFGKDUDKNENUDQ@KK@BBTQ@BXENQSGD
measurement chain is guaranteed.
4.2.1.1. Range
TE-18 TE-18 TE-25 TE-35 TE-45 TE-55
Pitch
LL LL 25 mm 35 mm 45 mm 55 mm
Nominal
current
range In
Ű Ű Ű Ű Ű Ű
Maximum l
Ű Ű Ű Ű Ű Ű
Part number
     
TE-90
Pitch
LL
Nominal
current
range In
Ű
Maximum l
Ű
Part number
