1
SAFETY INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS - Read and follow all instructions.
drugs or medication when using your Softub.
If you are pregnant, have heart disease, high blood pressure or other medical conditions, consult your doctor before
using your Softub.
People with infectious diseases should not use the Softub.
Do not stay in the Softub too long. 20 minutes should be the maximum depending on the temperature.
Have a companion nearby when using your Softub. Always have an adult accompanying children.
Check the water temperature with a thermometer before entering the Softub to ensure it is in the safe range.
The maximum safe temperature is recognized to be 38 (100.4 F).
Do not keep lamps, radios and other electrical appliances within 1.5 m (5 ft) of the Softub.
Keep the environment around your Softub safe and free of hazards.
Do not sit on the bi-fold lid of your Softub.
Fill tub with water BEFORE plugging into electrical outlets.
A water-proof hood should be installed on outdoor electrical outlets and is available from your Softub Dealer.
Use a properly grounded outlet of 110 Volt AC.
Do not put Softub on floors or other surfaces that are not structurally strong enough to support a load of 125 lb/sq.ft.
(611 kg/sq.m.) and/or on any floors or other surfaces that will not withstand exposure to water.
Maintain water chemistry in accordance with manufacturer’s instructions.
This appliance is provided with a ground fault circuit interrupter (GFCI) located on the power supply cord. Before each
use, with the plug connected to the power supply and with the unit operating, push the “TEST” button. This will turn
the power off going to the HydroMate . Next, push the “RESET” button. The unit should now operate normally. If
the interrupter fails to operate in this manner, there is ground current flowing, indicating the possibility of an electrical
shock. Disconnect the plug from the receptacles until the fault has been identified and corrected.
Do not use gas chlorination, ionizers, salts or soaps without consulting your dealer.
A wire connector is provided under the motor unit to permit connection of a minimum No. 8 AWG (8.4 mm) solid
copper conductor between this point and any metal equipment, metal enclosures or electrical equipment, metal water
pipe or conduit within 5 ft (1.5 m) of the unit.
DANGER - RISK OF ELECTRIC SHOCK. Install at least 5 ft (1.5 m) from all metal surfaces.
A spa may be installed within 5 ft of metal surfaces if each metal surface is permanently connected by a minimum No. 8 AWG
(8.4 mm) solid copper conductor to the wire connector under the motor unit which is provided for this purpose.
· Avoid alcohol,
·
·
·
·
·
· °C °
·
·
·
·
·
·
·
·
·
®
·
·
·
To Next Page
Loading...
