INSTALLATION INSTRUCTIONS
SITE SELECTION
Before selecting a site, please read the safety information, manufacturer’s warnings and the relevant indoor/outdoor sections.
Your Softub is completely self-contained and portable. It can be set-up on a patio, deck or even indoors.
A) Structure: the Softub should always be placed on a structurally strong, relatively smooth and level surface (see
specifications on page 14 for loading capacity).
B) Drainage: do not place the HydroMate in an area where water will puddle around it.
C) Electrical: allow easy access to the ground fault circuit interrupter (GFCI) which is located on the power supply cord. The
110 Volt GFCI and the outlet it is plugged into, should be protected from extreme weather, landscape sprinklers and
accidental spills.
D) Plug the HydroMate into a 110 Volt outlet without the use of an extension cord and a minimum of 3 m (10 ft) from
HydroMate . Be sure to use a grounded electrical outlet that fits properly to the plug. The Softub cord has a special
plug (called a ground fault interrupter or GFCI) that is a very important safety feature. The GFCI shuts off electricity to the
HydroMate immediately if there is a short in the cord or HydroMate . It is designed to be tested before each use. Be
sure to push the GFCI “RESET” button to activate the power after plugging the GFCI into the electrical outlet. This plug fits
all conventional 110 Volt outlets found in homes.
E) A pressure wire connector is provided in the under side of the motor unit to permit connection of a minimum No. 8 AWG
(8.4 mm) solid copper bonding conductor between this point and any metal equipment, metal enclosures or electrical
equipment, metal water pipe or conduit within 5 feet (1.5 m) of the unit as needed to comply with local requirements.
OUTDOOR INSTALLATION
You may place the Softub on any smooth surface (tile, concrete, wood, brick). Verify there are no sharp objects under the tub
prior to set-up. Placing the Softub on grass or other vegetation may damage the Softub. If you need to step on grass or dirt
to get to the Softub, we recommend the use of stepping stones to reduce the amount of dirt and debris entering the tub.
Check your local codes for restrictions (ie. childproof gates).
VERY IMPORTANT! We recommend that you set-up the Softub on a deck or deck patio tiles (available from your dealer)
that will allow proper airflow underneath the tub to prevent water from being trapped under the Softub and causing mildew
etc.
For easier maintenance, improved energy efficiency, better cleanliness and to prolong the life of your Softub, always use the
specially made exterior Tub Cover available from your dealer.
NOTE: An exterior Tub Cover is necessary if installing your Softub outdoors. Failure to do so will void the warranty.
INDOOR INSTALLATION
Water splashing on the floor during use may cause a walking hazard and/or structural damage unless good drainage is
provided. Proper building materials must be used in the area surrounding and beneath the tub. Take into consideration the
room humidity, which will exist due to high temperature. Providing natural or forced ventilation in the room will help maintain
comfort and minimize moisture damage to the surrounding environment. Consult an architect for aid in designing your indoor
Softub room.
®
®
®
®®
3
To Next Page
Loading...
