EasyManua.ls Logo

Softub 140 - Manufacturers Warnings

Default Icon
17 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
MANUFACTURER’S WARNINGS
In addition to the Safety Instructions found in this manual, these warnings have been assembled to
help you enjoy the use of your Softub. Reading and understanding these warnings will allow you to
reduce the risk of causing inadvertent damage to your Softub, your surroundings or yourself. Read
these warnings carefully.
The water level must be 5 cm above the highest jet. The jets can spray water out of the tub if the water level
becomes too low and cause the HydroMate to overheat and void the warranty.
Always unplug your HydroMate before draining and while filling.
Use only approved accessories. Use of non-approved accessories could void the warranty.
Maintain proper water pH (7.4-7.6), the vinyl liner can be damaged by a combination of high sanitizer and low pH.
NEVER use an extension cord to connect the HydroMate o the power supply cord. Using an extension cord will
void your warranty.
Do not operate without a GFCI located on the power supply cord. This safety device shuts off the power
immediately in the event of an electrical short.
Install the Softub only on floors or areas that can withstand repeated exposure to water (tile, brick). Splashing,
dripping, filling and draining are routine operations, which spill water. Equipment failure may also cause substantial
water spillage. Care must be taken that the structure underneath the Softub will not warp or suffer damage in the
event of a water spill. If located in a multiple floor structure, objects on the floor below should be protected in the
event of a major spill.
NEVER use sharp objects in or around the Softub. Sharp objects can puncture the vinyl.
Handle the HydroMate gently. The components inside may incur damage if dropped.
Certain objects reflect and concentrate the sun’s rays. Close proximity of the Softub to such objects should be
avoided or damage may incur.
Do not open the HydroMate . There are no user serviceable parts inside. Opening this component will void the
warranty.
Pets should be kept away from the Softub to avoid damage.
An exterior Tub Cover is necessary if installing your Softub outdoors. Failure to do so will void the warranty.
Do not install the Softub where infestation of insects or rodents may occur.
·
®
· ®
·
·
· ® t
·
·
·
· ®
·
· ®
·
·
·
2

Other manuals for Softub 140

Related product manuals