__1. Your Softub comes with safety straps for the cover. Be sure to lay
them down in an "X" fashion, then place the tub on top of them. Make
sure the straps are straight, centered, and that the tub is on a level
surface. Make sure the tub is placed where you want it to be.
Remember to leave room for a deck surround or steps. The tub cannot
be moved once its filled with water.
__2. Put the lid on the hot tub and test the straps to make sure that you
are able to fasten them properly.
__3. Set the Hydromate beside the Softub on the same level surface.
Align the pipes from the Hydromate with the fittings on the tub. DO NOT
PLUG IN THE UNIT.
__4. Slide the Hydromate towards the tub, directing the pipes to go in to
the fittings on the tub. Continue to push the Hydromate until all of the
black o-rings (2 on each pipe) are inside the fittings on the tub.
__5. Thread the connector nuts onto all 3 fittings until they are tight.
You may need to slide the Hydromate a little as you tighten the nuts. A
good indication they are tight is that none of the threads are showing on
the tub fittings.
__6. Connect the small wire connector for the light from the Hydromate
in to the wire connector on the tub.
__7. If your filter is not installed on one of the suction covers, soak the
filter connector in lukewarm water for two minutes (this makes the filter
easy to install). After soaking in warm water, snap the filter over the
fitting in the tub. (See filter information, page 20)
__8. Turn on the hose and allow the water to run into the grass or a
garden for a few minutes. This will rinse the inside of the hose of any
bacteria or algae (Both grow in stagnant water left in the hose when not
being used and could introduce contaminants to the tub). CAUTION:
Make sure not to fill the Softub with soft water.
10
To Next Page
Loading...
