JETS
When the water is at the set temperature, the jets will not be on. If you
wish to use the tub, the JETS button on the control panel activates a
timer that overrides the temperature you have selected. This turns the
jets on for a 20 minute period. If you want the jets to stop within that 20
minute period, press the jets button again. During use (lid off and air
valve open), the water temperature usually drops enough to allow the
thermostat to keep the Hydromate running after the 20 minute period. If
the motor stops after 20 minutes the jets button may be pressed again
to keep the Hydromate running.
FILTRATION
Softub’s patented filtration programming automatically runs if it
determines that it requires filtration. When the tub is running in the
filtration cycle, the filter icon will glow. The digital controls are set to run
two 15-minute filtration cycles in a 24 hour period. These will run every
12 hours and are set when the spa is first plugged in. The filtration cycle
will only run if there has been no heat call in the prior 12 hours. If there
has been a heat call, the filtration cycle will be skipped, saving you
money.
OZONE (If your Softub is equipped with ozone)
Ozone is a gas that is used as an aid to the sanitizer in the water.
Ozone helps to oxidize any contaminants in the water. The ozone is
controlled by a solenoid that automatically opens and closes an air
pathway to the body of water. In the event of a manual activation
(depression of the jets button) the ozone is automatically turned off and
will not run until the next heat call or filtration cycle. This prevents the
immediate contact with ozone as well as delaying the automatic
opening of the air control, which leaves the control of the air to the
discretion of the user.
AIR CONTROL
The main air control valve is located on the control panel of the
Hydromate. To open the air control, rotate the knob counter-clock-wise
one quarter of a turn. To close the air control, rotate the knob clockwise.
Each jet can also be individually directed by rotating the head of the jet.
After using your tub the air control should be turned off, so the addition
of outside air does not slow the heating of your tub.
See your Softub Dealer for optional jets which can customize your
Softub.
13
To Next Page
Loading...
