ii
PSX-NL4 Network Module - Operation Manual
Table of Contents
Notes and Warnings ......................................iii
Symbol Definitions ............................................................ iii
Warnings.................................................................... iii
Regulatory Information ......................................................... iii
Conventions Used Within this Manual.............................................. iii
Introduction............................................iv
Section 1 – Installation ....................................1
1.1.1 Mounting the PSX-NL4 Network Communication Accessory .........................1
1.1.2 Mounting the NS2 Output Controller Accessory...................................1
1.2 PSX-NL4 Network Communication Accessory Overview..............................2
1.3 Connecting the PSX-NL4 Network Communication Accessory . . . . . . . . . . . . . . . . . . . . . . . . . 4
Section 2 – Initial Configuration .............................. 8
2.1 Preparing to configure the PSX-NL4 ............................................8
2.2 Configuring the PSX-NL4 .....................................................9
2.3 Setting Up the PSX-NL4 for use with the MSM-200 multi-site manager ................18
Section 3 – Using the PSX-NL4 ............................. 19
3.1 Viewing System Parameters on the PSX-NL4 Home Page ...........................19
3.2 Accessing and Programming Connected Devices..................................20
3.3 Using the Tools Page .......................................................28
3.4 Understanding The Email Report ..............................................29
Appendix 1 – Software Agreement ........................... 30
i Resetting the PSX-NL4
If the IP address or user name/password is unknown for an PSX-NL4 board, press and hold the reset button located next
to the backup battery for five seconds. Note that this will reset the IP configuration information, user names, passwords,
and SNMP settings to the factory default values and will require reconfiguration of these fields.
To Next Page
Loading...
Need help?
General
