iii
Notes and Warnings
Symbol Definitions
The following symbols are used throughout this manual
h
This symbol is intended to alert the installer of
shock hazards within the enclosure. Service should
only be performed by qualified service personnel
i
This symbol is intended to alert the installer to impor-
tant information or information intended to help the
installer avoid personal injury or property damage
Warnings
h
Installation and service should be performed only
by qualified service personnel and should conform
to all local codes
h
To reduce the risk of electric shock or fire, do not
expose this equipment to rain or moisture
i
This equipment shall be installed in a manner
which prevents unintentional operation by employ-
ees, cleaning personnel, or others working in the
premises, by falling objects, customers, building
vibration, or similar causes
i
This equipment is not intended for use within the
patient care areas of a Health Care Facility
h
Replace fuses only with the same type and rating
as indicated in the specifications section of this
manual.
i
To prevent impaired operation, ensure that all wir-
ing is routed and secured to prevent accidental
open or short circuit conditions
i
The system and any batteries (if used) should be test-
ed at least once per year to ensure proper operation
Regulatory Information
The following equipment discussed within this manual has
been tested to the following standards:
• UL 294, UL 603, UL 1076
• ULC S318, ULC S319
The equipment in this manual is also an ETL Recognized
Component that Conforms to ANSI/UL Std. 294, ANSI/UL
Std. 2044 and is Certified to CAN/CSA Standard C22.2 No.
60950-1.
Conventions Used Within this Manual
Positional information (e.g. top, bottom, up, down, left, right,
etc.) is referenced with the board or enclosure in the orienta-
tion shown in the illustrations in this manual
To Next Page
Loading...