1. INTRODUCTION
To obtain the best performance from the machine and ensure the longest possible life of
all its components, you must carefully follow the instructions for use and maintenance
detailed in this manual. In the interest of our customers, we suggest any maintenance or
repair of the equipment has to be made by qualified personnel.
All our products are subject to constant development. Therefore, we are compelled to
reserve the right to make any necessary or useful changes in design and equipment.
2. ORDINARY MAINTENANCE
Exposure to extremely dusty, damp, or corrosive air is damaging to the
welding machine.
Avoid any deposit of metallic dust inside the generator.
Disconnect the generator from the net before operating any servicing!
Standard checks to the generator:
• Operate an internal cleaning by using low pressure compressed air and soft
bristle brushes.
• Check the electrical connections and all the rest of the connecting cables.
For the maintenance and the use of gas regulators consult the specific
handbook.
Please note that: lack of maintenance can spell to the unavailability and cancellation
of the guarantee.
3. POSSIBLE APPLICATION
Power sources type PLUS are suited for MIG / MAG applications with pulsation and synergy,
FCAW cored wire, MMA and TIG Liftarc with a range up to 210A.
• It is forbidden to use the equipment for different applications from the ones listed in
this manual. A different use from the one hereafter described can compromise the
security of work and the reliability of the equipment.
We suggest not to use the Inverter Power Source PLUS 210 C (standard version):
• In environments with a high concentration of humidity and dust.
• With Input cables longer than 50 m.
Contact the service centre for advice and precautions, in case the unit must be installed and
used under the above-listed conditions.
It is suggested to make a maintenance cleaning of the unit every 2-3 months of work,
for this operation, please contact the service centre.
To Next Page
Loading...