LCD display
With LCD plus LED displays, the user may easily understand the t UPS status and its
operational parameters, such as input/output voltage, frequency & load %, battery % and
ambient temperature, etc.
Intelligent monitoring function
Using the optional SNMP Card (optional for extra charge), you may remotely control and
monitor the UPS.
REPO function
REPO function (Remote EPO) is available in this series UPS.
3.3. System configuration
UPS device, external or internal batteries make up the system. Depending on the site and
load requirements of the installation, certain additional options are available for the solution.
Planning a UPS system, the following should be taken into consideration:
The total demand of the protected system shall dictate the output power rating (VA).
Allow a margin for future expansion or calculation inaccuracies from measured power
requirements.
Backup time required will indicate the battery size needed. If the load is less than the UPS
nominal power rating, then actual backup time is longer.
The following options are available with extra charge:
SNMP/WEB card
Relay card
Parallel connection
To Next Page
Loading...