SolarEdge SE Series User Manual

Chapter 3: Installing the Inverter
Install the inverter either before or after the modules and power optimizers have been
installed.
CAUTION!
Do not rest the connectors at the bottom of the inverter on the ground, as it
may damage them. To rest the inverter on the ground, lay it on its back.
Inverter Package Contents
One i nverter with DC Safety Unit (if applicable)
Mounting bracket kit
Quick installation guide
Warranty card
Safety instructions page
Technical Specifications page
Identifying the Inverter
Refer to the sticker on the inverter that specifies its Serial Number and its Electrical
Ratings. Provide the serial number when contacting SolarEdge support. The serial
number is also required when opening a new site in the monitoring platform.
Inverter and DC Safety Unit Interfaces
Figure 4 shows an inverter with a DC Safety Unit.
NOTE
The DC Safety Unit is applicable based on the inverter model and country of
installation.
Three Phase Inverter with SetApp Configuration PN: SEXXK-XXXXIXXXX
21 Chapter 3: Installing the Inverter

SolarEdge SE Series Specifications

General

Efficiency	Up to 99%
Protection Rating	IP65
Communication	Ethernet, Wi-Fi (optional), RS485
Dimensions	Varies by model
Weight	Varies by model
Rated AC Power	Varies by model
Max. DC Power	Varies by model
Model	SE Series (e.g., SE3000H, SE5000H)
AC Output Power	Varies by model
MPPT Range	Varies by model
Operating Temperature	-25°C to 60°C
Warranty	12 years standard, extendable to 20 or 25 years