Figure 10: Inverter fan - air flow
CAUTION!
Do not block the airflow from the inverter.
3. Position the mounting bracket against the wall/pole and mark the drilling hole
locations (refer to
Mechanical Specifications
on page 66 for inverter and mounting
bracket dimensions).
4.
Drill at least two holes and mount the bracket to the mounting surface. Verify that the
bracket is firmly attached to the mounting surface.
5.
Hang the inverter on the bracket (See
Figure 11
):
a. Lift the inverter from the sides, or hold it at the top and bottom.
b. Lower the inverter onto the U-shaped indentations of the mounting bracket. Let
the inverter lay flat against the wall or pole.
c.
Insert the two supplied screws through the outer heat sink fin on both sides of
the inverter and into the bracket. Tighten the screws with a torque of 4.0 N*m /
2.9 lb.*ft.
Chapter 3: Installing the Inverter 28
Three Phase Inverter with SetApp Configuration PN: SEXXK-XXXXIXXXX
To Next Page
Loading...
