SolarEdge SE3000 User Manual

Chapter 7: Setting Up Communication
The inverter sends the following information to the monitoring platform:
Power optimizer information received via the DC power lines (the PV output
circuit).
Inverter information
Information of any other connected devices.

This chapter describes setting up communication between:
The inverter and the monitoring platform through the Internet (wired/ wireless),
or through a cellular connection.
Multiple inverters for a master/slave configuration.
Communication setup is not required for power harvesting, however it is needed for
using the monitoring platform.
CAUTION!
When connecting the communication cables, make sure that the ON/OFF
switch at the bottom of the inverter (and the switch of the DC Safety Unit if
applicable) is turned OFF, and the AC is turned OFF.
When configuring the communication parameters while the inverter cover is
removed , make sure that the ON/OFF switch (and the switch of the DC Safety
Unit if applicable) is OFF, and the AC is turned ON.
Communication Options
The following types of communication can be used to transfer the monitored
information from the inverter to the monitoring platform.
Only communication products offered by SolarEdge are supported.
Always connect the communication options when the relevant devices are powered
down - Commercial Gateway, inverter, etc.
Ethernet
Ethernet is used for a LAN connection. For connection instructions refer to .
-Three Phase System Installation Guide MAN-01-00057-4.1
66 Chapter 7: Setting Up Communication

SolarEdge SE3000 Specifications

General

Model	SE3000
Manufacturer	SolarEdge
AC Output Power	3000 W
Cooling	Natural Convection
Protection Rating	IP65
Rated AC Power	3000 W
Max. AC Power	3000 VA
Maximum Output Current	13 A
Number of MPP Trackers	1
Operating Temperature Range	-25°C to 60°C
AC Voltage	230 V
Max. Input DC Voltage	480 V