SolarEdge SE4000H User Manual


WARNING!
Before operating the inverter, ensure that the inverter AC power cable and wall
outlet are grounded properly. This product must be connected to a grounded,
metal, permanent wiring system, or an equipment-grounding conductor must
be run with the circuit conductors and connected to the equipment grounding
terminal or lead on the product.
WARNING!
Opening the inverter and repairing or testing under power must be performed
only by qualified service personnel familiar with this inverter.
WARNING!
Do not touch the PV panels or any rail system connected when the inverter
switch is ON, unless grounded.
WARNING!
SafeDC complies with IEC60947-3 when installing the system with a worst case
SafeDC voltage (under fault conditions) < 120V.
The worst case voltage is defined as: Voc,max+ (String Length-1)*1V, where:
Voc,max = Maximum Voc (at lowest temperature) of the PV modules in the
string (for a string with multiple modules, use the max value)
String Length = number of power optimizers in the string
CAUTION!
This unit must be operated according to the technical specification datasheet
provided with the unit.
CAUTION!
HEAVY OBJECT. To avoid muscle strain or back injury, use proper lifting
techniques, and if required - a lifting aid.
NOTE
Use PV modules rated according to IEC 61730 class A.
IMPORTANTSAFETYINSTRUCTIONS 7
EV Charging Single Phase Inverter Guide MAN-01-00583-1.5

SolarEdge SE4000H Specifications

General

Model	SE4000H
Manufacturer	SolarEdge
AC Output Power	4000 W
Rated AC Power	4000 W
Max. AC Power	4000 VA
AC Voltage	240 V
Max. Input DC Voltage	480 Vdc
Dimensions	26.2 x 15.4 x 8.3 in
Weight	44.1 lbs
Cooling	Natural Convection
Protection Rating	IP65
AC Voltage Range	211-264 V
Frequency	60 Hz
Number of MPP Trackers	1
Protection Degree	IP65
Max. Output Current	16.7 A
MPPT Voltage Range	380 - 480 Vdc
Max. DC Input Current	15 A
Operating Temperature Range	-25°C to 60°C
Maximum Efficiency	99%
Max. Efficiency	99%