Solaris Flare / Flare Jr. user manual version 9.1 111215
SAFETY INSTRUCTIONS
Please keep this Operation Manual for future reference. If unit is sold to another user, make sure they also
receive this instruction booklet.
Ensure fixture is connected to proper voltage, and that line voltage is not higher than that stated on the
fixture.
Make sure there are no flammable materials close to the unit while operating.
Always disconnect from the power source before servicing or fuse replacement. Always use the fuse
specified in this manual.
Always use a safety cable when hanging fixture overhead.
Maximum ambient temperature (Ta) is 40°C (104°F). Do not operate fixture at temperatures above this
rating.
In the event of a serious operating problem, stop using the unit immediately. Repairs must be carried out by
trained, authorized personnel. Contact the nearest authorized technical assistance center. Only OEM spare
parts should be used.
Do not connect the device to a dimmer pack.
Make sure power cord is never crimped or damaged.
Never disconnect power cord by pulling or tugging on the cord.
Avoid direct eye exposure to the light source during operation.
Caution! There are no user serviceable parts inside the unit. Do not open the housing or attempt any
repairs yourself. In the unlikely event your unit may require service, please contact your distributor.
Technical Features / Description
Flare: 96 10W RGBW Cree
®
LEDs, divided into 2, 3, 4, 6 or 12 pixels
Flare Jr: 32 10W RGBW Cree LEDs, divided into 1, 2, or 4 pixels
Variable intensity control 0-100% in 8bit or 16bit control modes
Beam spread: 36°
Refresh rate: 1200HZ
Flash Duration control 0-650ms flashes per second
Flash Rate control 0-16.7Hz (50Hz) / 0-20Hz (60Hz)
Continuous blinder/wash effect
Flash intensity curve selection
User definable fades
LCD control panel display with 4 control buttons
Please read these instructions carefully. This user guide
contains important information about the installation, usage and
maintenance of this fixture.
To Next Page
Loading...