5. Installation
5.1 Check for Transport Damage
5.2 Packing Lists
16
17
Technical Data Installation
Make sure the inverter is intact during transportation. If there are some
visible damages, such as cracks, please contact your dealer immediately.
Open the package and fetch out the product, check the accessories at first.
The packing list is shown as below.
5.3 Installation Precaution
X1 Series inverter is designed for outdoor installation (IP 66).
Make sure the installation site meets the following conditions:
• Avoid exposure to glare.
• Avoid placing in areas where highly flammable materials are stored.
• Avoid placing in potential explosive areas.
• Avoid placing near the television antenna or antenna cable.
• Avoid placing in an altitude of higher than 4000 m above sea level.
• Be sure the ventilation is good enough.
• The ambient temperature and relative humidity must meet the following
requirements respectively: +60°C~25°C; 0~100%.
• The slope of the wall should be within ±5°.
The wall hanging the inverter should meet conditions below:
• Solid brick/concrete, or strength equivalent mounting surface;
• Inverter must be supported or strengthened if the wall's strength isn't
enough (Such as wooden wall, the wall covered by thick layer of
decoration).
Please avoid direct sunlight, rain exposure, snow laying up during
installing and operating.
Inverter can be installed inside an enclosure, make sure it meets the above
requirements, the following space size requirements and enough ventilation.
NOTE!
For the optional accessories, please be subject to the
actual delivery.
Inverter × 1
Bracket × 1
(Expansion tube,
flatgasket, self-tapping
screw) × 3
M5*L12 screw × 11
Earth terminal × 1
AC connector × 1
DC pin contact (2 ×
positive, 2 × negative)
RJ45 terminal × 1
Dongle (optional) × 1
Documents
Female DC unit × 2;
Male DC unit × 2
System data
Overvoltage Category
Inverter Topology
Model
X1-
BOOST-
3K-G4
X1-
BOOST-
3.3K-G4
X1-
BOOST-
3.6K-G4
X1-
BOOST-
4.2K-G4
X1-
BOOST-
5K-G4
X1-
BOOST-
6K-G4
X1-
BOOST-
2.5K-G4
III (MAINS), II (DC)
Non-isolated
Active anti-islanding method
Frequency Shift
To Next Page
Loading...
