20
Installation Installation
21
b) Drill holes with a drill (drill bit: 10 mm), make sure the holes are deep
enough (at least 60 mm) for installation.
c) Insert the expansion tubes in the holes, place the wall bracket and use
self-tapping screws to tighten the bracket.
Step 2: Match the inverter with the wall bracket
d) Hang the inverter over the bracket, move the inverter close to it, slightly
lay down the inverter, and make sure the 2 mounting bars on the back are
fixed well with the 2 grooves on the bracket.
Ø
Step 3: Fix the inverter with the wall bracket
e) Fix the right hole of the inverter by using the hexagon socket
head cap screw M5*L12.
Ø
To Next Page
Loading...
