9 Decommissioning
9.1 Dismantling the Inverter
Switch off the DC and AC switch/breaker and disconnect the inverter from
DC Input and AC output.
Wait for 5 minutes for de-energizing.
Disconnect communication and optional connection wirings.
Remove the inverter from the bracket.
If possible, please pack the inverter with the original packaging.
If it is no longer available, you can also use an equivalent carton that meets the
following requirements.
• Suitable for loads more than 80 kg.
• With handle.
• Can be fully closed.
Store the inverter in dry place where ambient temperatures are always between
-25°C - +60°C. Take care of the inverter during the storage and transportation,
keep less than 4 cartons in one stack.
When the inverter or other related components need to be disposed. Have it
carried out according to local waste handling regulations. Please be sure to deliver
wasted inverters and packing materials to certain site, which can assist relevant
department to dispose and recycle.
9.2 Packaging
50
Decommissioning
WARNING!
Before dismantling the inverter, please be sure to disconnect the DC
switch, and then unplug the PV and AC cables, otherwise it will lead
to an electric shock hazard.
9.4 Disposing of the X3-Forth
If the X3-Forth service life expires, dispose of it according to the local disposal rules
for electrical equipment waste.
9.3 Storage and Transportation
51
Disclaimer
X3 series inverters are transported, used and operated under limited condition, such
as environmental, electrical etc. SolaX shall not be liable to provide the service,
technical support or compensation under conditions listed below, including but not
limited to:
10 Disclaimer
• Inverter is damaged or broken by force majeure (such as earthquake, flooding,
thunderstorm, lighting, fire hazard, volcanic eruption etc).
• Inverter's warranty is expired and doesn't buy extended warranty.
• Can't provide the inverter's SN, warranty card or invoice.
• Inverter is damaged by man-made cause. Inverter is used or operated against any
items in local policy.
• Inverter's installation, configuration, commissioning doesn't follow the requirements
mentioned in this manual.
• Inverter is installed, refitted or operated in improper ways mentioned in this manual
without authority from SolaX.
• Inverter is installed, operated under improper environment or electrical condition
mentioned in this manual without authority from SolaX.
• Inverter is changed, updated or disassembled on hardware or software without
authority from SolaX.
• Obtain the communication protocol from other illegal channels.
• Build monitoring, control system without authority from SolaX.
• Connect to other brands batteries without authority from SolaX.
• SolaX will keep right to explain all the contents in this user manual.
To Next Page
Loading...
Need help?
General
